Publicité
Les langues disponibles
Les langues disponibles
74 electrolux
°dH
51 - 70
43 - 50
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
1) No use of salt required.
The water softener is set at the factory
at level 5.
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold function buttons B and C
until the indicator lights for function but-
tons A, B and C start to flash.
4. Release function buttons B and C.
5. Press function button A.
– The indicator light for function button A
continues to flash.
– The indicator lights for function buttons
B and C go off.
– The end-of-programme indicator light
starts to flash.
Use of dishwasher salt
Caution! Only use dishwashers salt.
Types of salt that are not applicable for
dishwashers cause damage to the water
softener.
Caution! Grains of salt and salty water
on the bottom of the appliance can
cause corrosion. Fill the appliance with
salt before you start a washing
programme to prevent corrosion.
Do these steps to fill the salt container:
1. Turn the cap anticlockwise to open the
salt container.
2. Fill the salt container with 1 litre of water
(only the first operation).
3. Fill the salt container with salt.
All manuals and user guides at all-guides.com
Water hardness
°TH
mmol/l
91 - 125
9,1 - 12,5
76 - 90
7,6 - 9,0
65 - 75
6,5 - 7,5
51 - 64
5,1 - 6,4
40 - 50
4,0 - 5,0
33 - 39
3,3 - 3,9
26 - 32
2,6 - 3,2
19 - 25
1,9 - 2,5
7 - 18
0,7 - 1,8
< 7
Clarke
64 - 88
53 - 63
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 0,7
< 5
– You can hear an audible signal.
The setting function of the water softener
is activated.
The end-of-programme indicator light
flashes and an audible signal operates to
show the level of the water softener. The
pause is approximately 3 seconds.
Example: 5 flashes / 5 intermittent audible
signals - pause - 5 flashes / 5 intermittent
audible signals - pause - etc. = level 5
6. Press the function button A one time to
increase the water softener level by one
step.
7. Press the on/off button to save the oper-
ation.
4. Remove the salt around the opening of
the salt container.
5. Turn the cap clockwise to close the salt
container.
Water hardness
setting
10
9
8
7
6
5
4
3
2
1)
1
Publicité
