ABB ACS580-04 Guide D'installation page 4

4 EN – Quick installation guide
5. Measure that the installation is de-energized.
•
Use a multimeter with an impedance of at least 1 Mohm.
•
Make sure that the voltage between the drive module input power terminals
(L1/U1, L2/V1, L3/W1) and the grounding (PE) busbar is close to 0 V.
•
Make sure that the voltage between the drive module UDC+ and UDC- terminals
and the grounding (PE) busbar is close to 0 V.
6. Install temporary grounding as required by the local regulations.
EN
7. Ask for a permit to work from the person in control of the electrical installation work.
DA
Select the power cables
Size the power cables according to local regulations to carry the nominal current given on
DE
the type designation label of your drive.
Ensure the cooling
ES
See table G on page
allowed operating temperature range of the drive without derating is -15 to +40 °C.
FI
Protect the drive and input power cables
FR
See table G on page 96.
Install the drive module into a cabinet
IT
See figure B on page 95:
•
Install the punched section to the back of the cabinet frame.
NL
•
Remove the pedestal guide plate from the bottom of the drive module.
•
Install the support rails and pedestal guide plate to the cabinet bottom frame.
PL
•
Install the telescopic insertion ramp to the pedestal guide plate.
For option +B051: See figure
PT
•
Remove the sheeting from the clear plastic shrouds from both sides.
See figure D on page 95:
•
Install the mounting bracket to the drive module.
RU
•
For option +B051:
•
Install the bottom grille to the drive module if there is no bottom plate in the cabinet
SV
and degree of protection of IP20 is needed for the drive module from the bottom
side.
TR •
Install the top metallic shroud to the drive module.
•
Install the back shrouds to the drive module.
ZH
See figure E on page 95:
•
Attach the drive module to the cabinet frame with chains.
•
Push the drive module into the cabinet along the telescopic insertion ramp.
•
Remove the ramp.
See figure F on page 95:
•
Attach the drive module to the pedestal guide plate.
•
Attach the drive module from top to the punched section at the cabinet back. Note:
The mounting bracket grounds the drive module to the cabinet frame.
All manuals and user guides at all-guides.com
96 for the losses and the cooling air flow through the drive. The
C on page 95: