Leelbox BQH2800II Manuel D'exploitation page 23

3.Connect to electrical
devices
1.Inspect power cord for
damage before using.
There is a hazard of
electrical shock from
crushing,cutting or heat
damage.
2.Make sure that the
generating set has been
properly grounded.If the
electric devices require
grounding，the generating
set must ground.
3.Make sure that the electric
devices are in "OFF"
position.
4.Allow the engine to stabilize
and warm up for a few
minutes after starting.
5.Connect and start the
electric devices.
6.Turn off all electric devices
and disconnect them from
the generating set.
7.If the generating set
supplies for several loads or
electric devices,start the
smallest one first and the
largest one last.
DANGER
If connected devices
overheat,turn them off and
disconnect them from
generating set.
ELECTRICAL SHOCK
To reduce the risk of
electrical shock,DO NOT
use electrical cords that are
worn,frayed,bare or
otherwise damaged.
DO NOT touch bare wires or
receptacles.
DO NOT handle generating
set or electrical cords while
standing in water,while
barefoot,or while hands or
feet are wet.
Loading capacity
DO NOT overload the
generating set.
Exceeding the generating
set's capacity can damage
the generating set and/or
electric devices connected to
it.
You must make sure your
generating set can supply
enough rated(running)and
(starting)watts for the electrical
devices at the same time.
Follow these simple steps to
calculate the running and
starting watts necessary for
your purposes.
a.Count the electrical devices
you will power at the same time.
b.The amount of power you
need to run with the devices is
the total rated(running)watts of
these items.
20
DANGER
WARNING