Installation Instructions - Proline PCI300G-E Guide D'utilisation

Figure A
! Before installation, read the instructions carefully.
! Fit the refrigerator/freezer in stable kitchen units only.
! If necessary, reverse the door according to instructions.
! Check the installation dimensions according to fig.C. The position of the joint between
the unit doors must be level with the position of the joint between the appliance doors.
1. See fig.A for the necessary attachment components.
2. Insert trim flap1 into slot and screw by screws6. (fig.D)
3. Pass the power cord through ventilation shaft and position it so that the appliance
could be easily plugged in once it has been installed. (fig.B - fig.C)
4. Take out the trim gasket2 located on the side panel of the appliance and stick it on
reverse side of the door hinges of the appliance. (fig.D - fig.E)
5. Raise appliance and slide into kitchen unit. Push appliance to the reverse side of
door hinges providing that trim gasket2 covers space between appliance and the
kitchen unit.
6. Align front feet with front surface of kitchen unit. (fig.F)
7. Screw the front feet by using screws5. (fig.F)
8. Screw trim flap1 to kitchen unit using screws5. (fig.G)
9. Screw fixing bracket11, as leaned to kitchen unit by using screws5. Repeat this for
the opposite side. (fig.H)
10. Screw guides3 to appliance doors with screws6. Lean appliance doors to unit
door as it is opened at right angle. Slide rails4 into guides3 aligning the groove.
Screw the rails4 to the unit doors with screws5. (fig.J)
11. Set 1~2 mm gap on handle side between unit itself and unit doors by adjusting
guides3. That is vital for appliance performance. (fig.J)

INSTALLATION INSTRUCTIONS

Ø4 x 17
Ø4.2 x 9.5
UK - 3 -