Switching On The Appliance - Proline PCI300G-E Guide D'utilisation

REFRIGERANT
• The refrigerating gas contained in the circuit of this appliance is Isobutene (R600a);
it causes a low level of pollution but is inflammable.
CAUTION:
• Extreme caution must be used when moving the appliance.
WARNINGS:
• Do not damage the refrigerant circuit.
• Do not use sharp or pointed objects such as knives to remove ice when defrosting.
• Do not use mechanical devices or other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
• Do not use electrical appliances inside the food storage compartments of the
appliance, unless they are of the type recommended by the manufacturer.
• If the appliance is installed in a carpeted area, do not let the carpet block the ventilation
holes in the base of the unit, adjust the levelling feet after a few hours to compensate
for carpet movement.
• Keep ventilation openings, in the appliance enclosure or the built in structure clear
of obstructions.

Switching On the Appliance

• Before switching on, place the appliance in a upright position and wait at least three
hours without moving the appliance. This will give the refrigerant circuit time to settle
and operate efficiently.
• Clean the appliance thoroughly, especially in the interior, before use (See Cleaning
and Maintenance).
• Installation of the appliance and electrical connections must be carried out by a
qualified technician, in accordance with the Installation Manual and local regulations.
• Installation into the kitchen unit is explained in the Installation Manual. This product
is intended to be used in dedicated kitchen units only.
• Check that the voltage marked on the rating plate corresponds to the supply in your
area.
Their must be a dedicated 13A socket that is permanently accessible for the exclusive
use of this appliance.
• Insert the plug into a socket with an efficient ground connection. If the socket has no
ground contact or the plug does not fit, we suggest you to call a qualified electrician
for assistance.
• Manufacturer is not responsible for failure to complete the ground connection as
described in this booklet.
• There may be an odor when you first switch on the appliance. It will disappear after
the appliance starts to cool.
UK - 8 -