Toro Power Max e26 Mode D'emploi page 24

After Operation
Shutting Off the Machine
1. Release the traction and auger/impeller levers.
2. Turn the key to the O
from the control panel
3. Remove the battery pack(s); refer to
the Battery Pack from the Machine (page
Note:
Whenever you are not using the machine,
remove the battery pack(s) and the key from
the machine.
Note:
If the machine is turned on and left idling
or operating without the auger engaged for an
extended period, the motor shutoff timeout will
engage, shutting off the machine. When the
machine shuts off this way it beeps to indicate
that the timeout was engaged.
To restart the machine refer to
Machine (page 17).
Removing the Battery Pack
from the Machine
1. Lift up the battery-compartment lid.
2. Press the battery pack-latch to release the
battery pack and remove the battery pack
(Figure 27).
Figure 27
3. Close the battery-compartment lid.
position and remove it
FF
(Figure 12).
Removing
22).
Starting the
Preventing Freeze-up after
Use
•
In snowy and cold conditions, some controls and
moving parts may freeze. Do not use excessive
force when trying to operate frozen controls.
If you have difficulty operating any control or part,
start the machine and let it run for a few minutes.
•
After using the machine, let the machine run for a
few minutes to prevent moving parts from freezing.
Engage the auger/impeller to clear any remaining
snow from inside the housing. Rotate the Quick
Stick to prevent it from freezing. Shut off the
machine, wait for all moving parts to stop, remove
the key and the battery, and remove all ice and
snow from the machine.
•
Clean off any snow and ice from the base of the
chute.
•
Rotate the discharge chute left and right to free
it from any ice buildup.
g347853
22