Transcend 365 miniCPAP Auto Guide Rapide page 18

Transcend 365 miniCPAP Auto Quick Guide
Press center button
Note: If the miniCPAP Auto™ device loses power while delivering therapy, the CPAP will
power on as soon as power is restored. The user must hit the Center button to resume
therapy.
Using the Ramp Function
Initiate Ramp by pressing the Down button after the Power button has been pressed
1.
(when CPAP is already delivering air pressure).
Pressure from the device will be lowered to a preset starting pressure and will
2.
gradually increase to your prescribed starting pressure.
To accelerate Ramp time, hold down the Down (Ramp) button. The device will quickly
3.
increase pressure until reaching your prescribed therapy pressure.
Ending therapy and entering Drying Mode
When you are finished with your therapy session, press the Center button to return your
CPAP to Standby mode. Press and hold the Up and Down buttons for three seconds to
start Drying Mode. This mode will last 30 minutes unless you interrupt it by pressing any
button. After the 30-minute drying cycle, the blower will turn off and the device will
automatically enter Standby Mode.
Dry mode flushes your CPAP device, tubing and mask of any residual moisture left from a
therapy session.
All manuals and user guides at all-guides.com
to begin therapy.
Then press down
button to begin ramp.
Page 18