Transcend 365 miniCPAP Auto Guide Rapide page 17

Transcend 365 miniCPAP Auto Quick Guide
Standard user modes
Normal operation consists of four modes:
Off When the device is not connected to a power source, the device is off.
Standby When power is applied to the device the LCD screen lights up and the CPAP
enters Standby Mode. Standby Mode is also initiated by pressing the power
button when the device is in On Mode or if the mask is removed while in On
Mode. As long as power is supplied to the device it will remain in Standby
Mode until On or Drying Mode is initiated.
On When in On Mode, the blower is working and regulated device therapy
pressure is being generated. The LED lights remain off. On Mode is initiated
by pressing the center button when the device is in Standby Mode and the
mask is worn by the patient.
Drying This mode is accessed from Standby mode. Press and hold the Up and Down
Mode buttons at the same time for three seconds to start Drying Mode. This mode
will last 30 minutes unless you interrupt it by pressing any button. Drying
mode flushes your CPAP device, tubing and mask of residual moisture left
from a therapy session.
Starting Therapy
Allow the Transcend 365 miniCPAP Auto to adjust to ambient temperature after
removing it from storage. To begin therapy, plug in the power supply to your Transcend
365 miniCPAP Auto and press the center button to begin therapy. Press the down button
to activate Ramp, if desired.
Note: To begin therapy from the home screen, first ensure that no icons are
highlighted,then press the center button. You may also start therapy from any screen by
holding the center power button for three seconds.
All manuals and user guides at all-guides.com
Page 17