Getting Started - weewell WMV860 Mode D'emploi

Getting started

Plug in baby unit power adapter
• Make sure to use provided (6V 800mA) power adapter, the longer cable one.
• Slide the switch to on position to turn on baby unit. Green power LED is turned on.
Plug in parent unit power adapter
• Make sure to use provided (6V 800mA) power adapter, the shorter cable one.
• Plug in adapter to parent unit to charge parent unit for at least 4 hours the first time
use the baby monitor.
• Press and hold power on/off key for 2 seconds to turn on parent unit.
• Once the baby and parent units are switched on, the display on the parent unit will
show the video captured by the baby unit.
• If there is no connection or you are out of range, the video display will go off and
the LOST LINK signal will be shown on the LCD display with beep sounds beeps
every 3 seconds. Move the parent unit closer to the baby unit until the link is re-
established.
I 9
WMV860 USER MANUAL