Midea MP08DRWBA3RCM Manuel De L'utilisateur page 15

Before assembly
Window
Sliders
After assembly
Bolt
1+2：
Bolt Bolt
1+2+3：
Bolt Bolt
1+2+3+4：
Bolt
1+4：
Note: Once the exhaust eose assembly and adjustable window slider are prepared,
choose from one of the following installation methods.
Type 1: Hung Window Installation
Foam seal B
(shorter adhesive type)
Cut the adhesive foam seal
A and B strips to the proper
lengths and attach them to
the window sash and frame
as shown.
Security bracket
2 screws
If desired, install the
security bracket with
2 screws as shown.
Installation
Step Three: Preparing the adjustable
window slider
1. Choose the window sliders according to the size of your window.
Sometimes, sliders need to be cut short to meet the window size,
please take extra care to cut it properly.
2. Use bolts to fasten the window sliders once they are adjusted to
the proper length.
Window
Bolt
slider A
Hung Window
Foam seal A
(adhesive type)
Insert the window slider
assembly into the window
opening.
Insert the window slider
adaptor into the hole of
the window slider.
Windows Type
Window
slider A
Sliding Window
Window slider B
Window slider A
(if required)
14
Foam seal C
(non-adhesive type)
Cut the non-adhesive foam
seal C strip to match the width
of the window. Insert the seal
between the glass and the
window frame to prevent
air and insects from getting into
the room.