Publicité
Les langues disponibles
Les langues disponibles
Charging a USB device
The RH4-18V's USB port can also be used to charge USB
devices. The USB port has an output power of 5V / 1A.
To charge a USB device (e.g. iPhone, smartphone or
similar device), just open the USB rubber cover on the
right side of the radio and insert / connect it to the USB
port. After charging has finished, don't forget to remove
/ disconnect the device again and close the USB rubber
cover to prevent moist or dust from entering the radio.
Charge time may vary and in some cases may take longer
to charge than when using the manufacturers charging
unit supplied with the smart phone.
IMPORTANT:
● The USB jack can only provide power for the USB
memory stick only with 1A 5V maximum and most of
iPhone models. However, it does not support external
Hard disk drive and all mobile phones and electronic
device.
● The maximum volume of the output power speaker will
decrease when your USB is charging.
● The charger may not supply power to some USB devices.
● Do not connect power source to USB port. Otherwise
there is risk of fire. The USB port is only intended for
charging lower voltage device. Always close the USB
rubber cover when not charging the lower voltage
device.
● Do not insert a nail, wire, etc. into USB power supply
port. Otherwise a circuit short may cause smoke and
fire.
● Do not connect this USB socket with your PC USB port,
as it is highly possible that it may cause breakdown of
the units.
Listening to audio using the Aux in
socket
You can listen to the sound of an external device (such
as an iPod or MP3 player) through the speaker of the
RH4-18V. To do this, follow these steps:
1.
Open the Aux in socket's rubber cover and connect
the external device to the socket using a 3.5mm audio
cable.
2.
Make sure both the radio and the external device are
turned on.
3.
Select the AUX IN mode by repeatedly pressing the
Source button.
4.
The audio output of the external device will now be
played through the speakers of the RH4-18V. Playback
must be controlled on the external device, while the
volume can be controlled both on the radio and on the
external device.
Note:
After disconnecting the 3.5mm audio cable, close the Aux
in socket's rubber cover again to prevent moist or dust
from entering the radio.
Microphone socket
A 6.3mm microphone socket is provided on the right side
of the radio for connecting a microphone.
1.
Connect the microphone (not supplied) to the
microphone (MIC) socket.
2.
Make sure both the radio and the microphone are
turned on.
3.
Adjust the volume control on the radio to the required
level.
Note:
● In USB or SD mode, when a USB or SD card is not
inserted into the radio, the microphone will not be
activated.
● Do not place the microphone against the speaker, it
can cause feedback echo and it will damage the radio.
Equalizer function (EQ)
The sound on your radio can be adjusted to suit your
personal taste for the songs you are listening to.
Press the EQ button to cycle through the various modes.
a.
Flat – no tone modification is applied.
b.
Rock
c.
Outdoor
d.
Pop
e.
News
f.
Indoor
g.
My EQ
If you find the preset equalizer functions not to your liking,
you may set up a custom treble and bass as following:
1.
Press and hold the EQ button to enter the My EQ setting.
2.
Rotate the Tuning knob to adjust the Treble level and
then press the Tuning knob to confirm the setting.
3.
Rotate the Tuning knob to adjust the Middle level and
then press the Tuning knob to confirm the setting.
4.
Rotate the Tuning knob to adjust the Bass level and
then press the Tuning knob to confirm the setting.
Loudness On / Off
When the radio is turned on, press the Loudness button
to enable or disable the radio's loudness function. When
the loudness function is applied, the characters in the EQ
mode (such as Flat) will change from white to orange.
WARRANTY
This radio has a 2 year limited warranty.
WARNING! Warranty becomes void once the radio cabinet
has been opened or any modifications or alterations to the
radio have been made!
The terms of the warranty of this radio do not cover the
following:
- Damage caused by misuse, abuse, neglect, alterations,
accidents or unauthorized repair.
- Normal wear and tear.
- Breaking or bending of the antenna.
- Batteries, being consumables, do not fall under the 2
year warranty conditions of the radio.
GB
NL
DE
FR
ES
ITA
SV
DAN
NOR
PL
9
Publicité
