Télécharger Imprimer la page

Hilti WSR 36-A Mode D'emploi Original page 25

Masquer les pouces Voir aussi pour WSR 36-A:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 30
All manuals and user guides at all-guides.com
WARNING
Risk of injury! Danger of kickback.
▶ Always use saw blades of adequate length. The tip of the blade must project at least 40 mm (1¹/₂")
beyond the reverse side of the workpiece during the blade stroke.
WARNING
Risk of injury! Caused by the chuck / accessory tool retaining mechanism
▶ Always hold the power tool securely with both hands on the grips provided. Never use the power
tool without a fully functional hand guard.
WARNING
Risk of injury by the blade holder / chuck
▶ Do not use the cover over the blade holder / chuck as a gripping area.
Note
The power tool must be pressed against the workpiece until the contact shoe makes firm
contact. This helps ensure maximum safety and good performance.
▶ Observe all safety instructions printed in this documentation and on the tool.
5.2 Removing the battery
1. Press the two release buttons and hold them in the pressed position.
2. Pull the battery out of the product to the rear.
5.3 Fitting the saw blade
Note
Use only saw blades equipped with a 1/2" connection end.
1. Engage the transport lock.
2. Check that the connection end of the accessory tool is clean and lightly greased. Clean it and grease it if
necessary.
3. Turn the chuck locking sleeve counterclockwise and hold it in this position.
4. Push the saw blade into the chuck from the front end of the tool.
5. Release the locking sleeve and allow it to click back and engage in its original position.
6. Grip and pull the saw blade to check that it is locked in position.
5.4 Removing the saw blade
1. Engage the transport lock.
2. Turn the chuck locking sleeve counterclockwise and hold it in this position.
3. Pull the blade forward out of the chuck.
4. Release the locking sleeve and allow it to move back to its original position.
5.5 Adjusting the contact shoe
Note
When the contact shoe is adjusted correctly the length of the blade can be used optimally and access
in corners is improved. The contact shoe engages in click-stop increments of 6 mm (¹⁵/₆₄").
Do not adjust the contact shoe while the power tool is in operation.
1. Engage the transport lock.
2. Remove the saw blade.
3. Press the contact shoe adjustment button and hold it in this position.
4. Slide the contact shoe to the desired position.
Printed: 30.05.2017 | Doc-Nr: PUB / 5071396 / 000 / 04
3
4
5
6
English
19

Publicité

loading