SOMFY Sonesse Ultra 50 Notice page 7

2.3. CommIssIonIng
To set the motor, use the RS485 SETTING
TOOL ref:9017142A
Connect the RS485 SETTING TOOL to the motor
switch on and follow the instruction on the RS485
SETTING TOOL (P34).
2.4. tIPs and reCommendatIons for InstallatIon
2.4.1. questions about the sonesse Ultra 50 rs485?
Observations
The wiring is incorrect.
The motorised
product does not
The motor is in thermal
operate.
protection.
An incorrect Data cable has been
used.
The motorised
The drive wheel and the crown
product is noisy:
are not suitable for the tube.
The motorised product is com-
pressed between the brackets
The tube contains swarf and
screws.
The motorised
The end-limits of the motorised
product stop to soon
product drift.
or to late.
Copyright © 2015 Somfy SAS. All rights reserved.
All manuals and user guides at all-guides.com
Possible causes Solutions
Check the wiring and modify it if
necessary.
Wait until the motor cools down.
Check the Data cable
Replace the drive wheel and the crown
Increase the play between the brackets
Clean the roller tube.
Readjust the end-limits
EN
7