Publicité
Les langues disponibles
Les langues disponibles
Press crutch down
This is accomplished by laying the bottom section of the boat on a flat surface, sponsons down, and
placing a weight inside the hull to keep it in this position.
The six steps of the sponsons must be left resting squarely on a flat surface until the glue has set
hard!
Tack the horizontal crutch
•
(part 6) to the ABS strips
(parts 2) using cyano.
When the glue has set
•
hard, apply Stabilit
Express or Acrylit to the
full length of the joint
between the crutch and
the sides of the bottom
hull section.
The sponson former (part
•
4) only needs to be spot-
glued to the hull floor.
Assemble the servo
•
mount from parts 7 and 8,
and glue it in the slots in
the transom
reinforcement and the
hull floor.
Important
Leave the boat weighted down on the flat surface while you check that the upper hull section fits
•
accurately.
The first step is to apply Stabilit Express to the front area of the top and bottom hull sections, then
•
place the top section on the bottom shell and position it accurately.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten!
All manuals and user guides at all-guides.com
Glue here
Insert
Glue with Stabilit Express
#0059939
04/2008
16
Publicité
