Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Connecting the amplifier/mixing console
The receiver's audio outputs are available as an XLR-3M socket
¼" (6.3 mm) jack socket
units (e.g. amplifier, mixing console). The adjusted audio output level is
common for both sockets.
Connect the amplifier/mixing console to the XLR-3M socket
¼" (6.3 mm) jack socket
For detailed information on balanced and unbalanced connection, please
refer to the section "Connector assignment" on page 30.
Via the operating menu, adapt the level of the audio output (AF OUT) to
the input of the amplifier or mixing console (see "Adjusting the audio
output level" on page 21).
Service interface
The service interface
19" rack adapter and antenna mount
For mounting one or two receivers into a 19" rack, you require the GA 2 rack
adapter (available as an accessory). The GA 2 rack adapter consists of:
2 rack mount "ears"
1 connecting bar
1 connecting plate
2 covering plugs
12 recessed head screws M 3x6
2 recessed head screws M 6x10
When mounting only one receiver into a rack, you can use the AM 2 antenna
mount (available as an accessory) to mount the receiver's antenna
connections to the front of the GA 2 rack adapter. The AM 2 antenna mount
consists of:
2 BNC extension cables (screw-in BNC socket
2 plains washers
2 nuts
, allowing you to simultaneously connect two
.
is only required for servicing purposes.
for antenna holes
to BNC connector
and a
or the
)
11
Publicité
