Factory Settings; Adjusting The Settings - aldes Cube 300 Notice De Montage

5.3 Factory settings

The unit is configured with the following settings
by default:

5.4 Adjusting the settings

Turn on the power to the unit
It will sometimes take between 30 seconds and 1 minute for the motors to start .
Constant
Mode
airflow
Speed 1
Speed 2
Speed 3
Speed 4
1 . Press the top button to select
the type of system to use:
• Constant airflow mode (balanced airflow extract and
supply fan)
• Constant pressure extract fan and electronically
balanced supply fan
2 . The buttons at the bottom are used to configure the sys-
tem according to the house
a . Select speed to set:
b . With and
(constant airflow mode), or required pressure
(constant pressure mode) .
3 . If necessary, adjust the balance between both motors
a. Press 'speed 2' +
at the same time .
b . Adjust the % dis-balance between extract and
supply motor .
4 . To restore default settings :
a . Press 'speed 2' +
b . Press or
42
Constant
pressure
100 50
120 100
210 120
240 140
ajust the required airflow
+ buttons
+ at the same time .
to set back to 0 .