General Information; Symbols; Important Recommendations And Remarks; Safety Instructions - aldes Cube 300 Notice De Montage

1. GENERAL INFORMATION

1.1 Symbols

Hazard or important information. Risk of injury and damage to equipment .
Follow the instructions carefully to prevent the risk of injury and damage to equipment .
Page references. References to other notices or other pages of the notice .
1.2 General information
We would like to thank you for choosing an ALDES product . We recommend that you read this manual and
follow the instructions carefully in order to ensure that your unit works correctly . As the manufacturer we
will not be responsible for any improper use, poor maintenance or lack of maintenance of the unit, nor
in the event of incorrect installation . In order to constantly improve the quality of our products, ALDES
reserves the right to modify the specifications included in this document at any time .
The correct operation of the unit depends on these instructions being followed carefully .
Failure to follow these recommendations may void the guarantee.

1.3 Important recommendations and remarks

Before installation, start up and maintenance of the Heat Recovery Ventilation unit please read
the "Warnings and Regulations" sheet supplied with the product .

1.4 Safety instructions

1.4.1 Mechanical hazards

• The equipment should be handled and installed in accordance
with its weight and dimensions .
• The unit should be installed in a dry place and should not be exposed to freezing temperatures
(interior installations) .
• The unit must be positioned as per the manufacturer's recommendations (chapter 4.2).
1 .4 .2 Starting up
• Do not attempt to install the unit yourself. This product must be installed and maintained by
qualified technicians .
• Do not modify the power supply.
• The unit is not explosion-proof and should not be installed in explosive atmospheres (ATEX).
• All connections must be made before starting the unit (aeraulic, electrical, condensation
drainage) . The unit must be started immediately after the connections have been established
to prevent condensation forming (chapter 5 .1).
• The product meets the requirements of the EN 55014-2 A1/A2 standard (97/01/08 edition)
concerning electrostatic discharge immunity .
28