4.4 - Electrical connections
Mains connection
The unit must be wired by a professional,
using the local standard of the country .
Connect the supplied cable to the mains using
a sealed junction box (not supplied) .
Cable cross-section: 3 x 1 .5 mm
Mains: 230 V single-phase alternating current .
The installation must include:
• A bi-polar circuit-breaker.
• Differential circuit-breaker protection with a rating
of 30 mA .
Option: pushbutton kitchen/BOOST flow rate control
A pushbutton may be installed in the kitchen to control
• Short press: to change from speed 2 to speed 3 (no timer).
• 3 seconds press: to change from speed 3 to speed 4 (no timer).
• Pressing again will return the system to speed 2.
Remove the electronics card access panel by removing the screw and then pressing the button at the top .
2
Remove the right filter access panel
by pressing on the two buttons at the top .
38
VUE 3/4 DESSUS SORTIE CORDON
230V connector .
Length of wire
available: 1 m