Alpine S-A60M Mode D'emploi page 9

, refer to Cautions on wire lead connections
ly Wires
When using third-party wire cables (power supply
upply
wire), use the supplied screws to simplify the
e of
connection. Refer to the description below for the
proper procedure. If you are in doubt about how to
y)
make this connection, consult your dealer.
1. Check the wire size.
our head
• For details on the wires size to be used, refer to
able, see
eads of
er-RCA
• If the wire gauge used is unknown, ask your
u do not
ead,
2. Remove the insulation from the ends of the wire
ion of
NG" leads by about 7 – 10 mm (9/32" – 13/32").
the
e,
y
re metal
point to
NOTES:
uity
• If length of the exposed wire is too short, a poor
connection may occur causing operation failure
all your
or sound interruption.
n the
• On the other hand, if the length is too long, an
eeping
electrical short-circuit may occur.
3. Tighten the hexagon hole screw with the
, refer to
ly Wires hexagon wrench (included) to secure the lead.
upply
Before making this connection, use insulated
e of
shrink tubing to cover any exposed wire
extending beyond the terminal.
Power Supply Terminal
s on your
r
arately).
ections;
This is an
ofer
affected
he
ace
the
Remote Turn-On Lead
the supplied "Cautions on Power Supply Wires
Connection" and "Cautions on Power Supply
Wires" (page 19), and then use the wire of
the specified size.
dealer.
7 – 10 mm
(9/32" – 13/32")
Lead end side of
the product
Twist the tip of wire leads
Hexagon Wrench (included)
Hexagon hole screw
Battery Lead
Ground Lead
Power Supply Terminal
Speaker Output Terminals
Hexagon Wrench (included)
Hexagon hole screw
Speaker Output Lead (+)
NOTES:
• Be sure to use the Hexagon hole screw attached
to the Power Supply Terminal ( ) or Speaker
Output Terminals ( ).
• For safety reasons, connect the battery leads last.
• To prevent disconnection of the leads or
dropping of the unit, do not use the cabling to
carry the unit.
(e.g. S-A32F)
ALPINE S-A60M/S-A32F/S-A55V 68-35792Z59-A (EN/FR/ES)
Speaker Output Terminals
Speaker Output Lead (–)
(e.g. S-A32F)
7
-EN
EN
FR
ES