Peg-Perego GT3 Notice D'emploi page 17

brake cable, slip it into the slot as shown in
the figure.
5 MOUNTING THE REAR WHEELS: To mount the
rear wheels, push them into the openings on
the sides of the stroller and click them into
place (arrow_a).
MOUNTING THE FRONT WHEELS: press the
button on the rear ledge (arrow_b) while
slipping the front wheel into place (arrow_c).
Pull downward on the wheels to make sure
they are securely fastened.
6 BASKET: Press the side buttons (fig_a) to
remove the basket (fig_b) and fit the material.
7 Slide the assembled basket into the housing
(fig_a). Attach it to the clips at the front
(fig_b) and on the sides (fig_c).
8 HOOD: to fit the hood, insert the side
fasteners into the special housings (fig_a),
button the hood to the back of the backrest
(fig_b) and to the inside of the armrests
(fig_c).
9 Lower the braces to stretch the hood (fig_a).
When you lift the movable part of the hood,
you will find a net insert that provides better
ventilation to the baby (fig_b). To remove the
hood, fold the braces, unbutton the hood,
press the side button (fig_c) while slipping
the hood fastener out of its housing (repeat
on the other side).
1 0 COVER: zip the cover to the footrest (fig_a),
fasten it to the side by the Velcro (fig_b) and
secure it with the button (fig_c).
1 1 FIVE POINT SAFETY HARNESS: To fasten it,
push the two waist strap buckles (with the
shoulder straps attached – arrow_a) into
the leg divider until they click into place
(arrow_b). To unfasten it, press the round
button in the centre of the buckle (arrow_c)
and pull the waist straps out (arrow_d).
1 2 To tighten the waist strap, pull on both sides
in the direction of the arrow (arrow_a). To
loosen it, do the opposite. The waist strap can
be tightened as far as the safety lock (fig_b).
1 3 To adjust the height of the safety harnesses,
release two the buckles on the rear of the
backrest; pull the shoulder straps towards you
(arrow_a) until the buckles are released and
insert them in the backrest loops (arrow_b).
Remove the shoulder straps from the sack
(arrow_c) and insert them in the most
appropriate loop (arrow_d), then re-attach
the two buckles on the rear of the backrest
(arrow_e).
1 4 BRAKE: to brake the stroller, pull the handle
on the handlebar towards you (arrow_a);
to release the brake, disengage the lever
(arrow_b). Always set the brake when the
stroller is not moving. To adjust the brake and
tighten it, unscrew the adjuster (fig_c) on the
handlebar to the outside. To loosen the brake,
do the opposite.
All manuals and user guides at all-guides.com
1 5 ADJUSTABLE HANDLEBAR: the handlebar on
1 6 SAFETY STRAP: The stroller features a safety
1 7 ADJUSTING THE BACKREST: the backrest
1 8 ADJUSTING THE FOOTREST: the footrest can
1 9 FRONT BAR: the practical front bar opens and
To open the front bar, press the button
2 0 SIDE CUP HOLDERS: the stroller is equipped
2 1 RAIN CANOPY: fit the rain canopy onto the
2 2 The practical rain canopy can be lowered and
2 3 POUCH: place the pouch near its own
2 4 SWIVELING OR STATIONARY FRONT WHEEL:
2 5 AIR PUMP: to inflate the tires, use the pump
- 17 -
the stroller is height-adjustable. To adjust
the height of the handlebar, simultaneously
press the side buttons (fig_a) and block the
handlebar in the desired position (fig_b).
strap on the handlebar. This is to be attached
to your wrist, to provide greater safety when
walking.
of the stroller can be reclined to several
positions. To lower the backrest, lift the
handle (arrow_a) as you recline the backrest
(arrow_b), locking it at the desired position.
To raise it, push the backrest up.
be adjusted to two positions. To lower the
footrest, pull the two side levers downwards
(fig_a) while lowering the footrest (fig_b). To
raise the footrest, lift it upwards until it clicks
into place.
closes to make it easier for the child to get in
and out of the stroller when he/she is older.
located under the armrest (arrow_a) and
pull the front bar outwards at the same time
(arrow_b). To close the front bar, do the
opposite. The front bar can be removed. The
front bar is also extendible – to extend the
front bar, press the long button located under
the armrest (arrow_c) and pull the front bar
outwards (arrow_d). To shorten the front bar,
press the long button and push the front bar
into the armrest.
with two side cup holders that fold away or
pull out as necessary. To pull the cup holder
out, turn the upper part upwards (arrow_a)
and lower the bottom part (arrow_b). Turn
the disk outwards (arrow_c) and place your
drink in the holder (fig_d) To close the cup
holder, do the opposite.
stroller and button it on the side to the hood
(fig_a), button the two sides of the rain
canopy elastic to the bottom of the front
frames (fig_b).
remains attached to the stroller through the
buttons.
housings, located on the handlebar, and
fasten it (fig_a). The pouch can be worn as an
accessory using the special belt (fig_b).
to set the front wheel on stationary, turn the
knob to the closed padlock (fig_a). To swivel
the front wheel, turn to the open padlock
(fig_b).