Peg-Perego GT3 Notice D'emploi page 16

EN_English
Thank you for choosing a Peg-Pérego
product.
WARNING
_ IMPORTANT: READ THESE
INSTRUCTIONS CAREFULLY
AND KEEP THEM FOR FUTURE
REFERENCE. FAILURE TO FOLLOW
THESE INSTRUCTIONS COULD PUT
THE CHILD'S SAFETY AT RISK.
_ THIS PRODUCT IS DESIGNED FOR A
CHILD WHOSE MAXIMUM WEIGHT
IS 45 POUNDS (20 KG) AND WHOSE
MAXIMUM HEIGHT IS 43 INCHES
(110 CM). THIS SHOPPER BASKET IS
DESIGNED TO CARRY A MAXIMUM
WEIGHT OF 11 POUNDS (5 KG). ANY
CUPHOLDER EVENTUALLY PROVIDED
WITH THIS UNIT IS DESIGNED
TO CARRY A MAXIMUM WEIGHT
SPECIFIED ON THE CUPHOLDER
ITSELF. ANY POACH OR POCKET
PROVIDED WITH THIS UNIT IS
DESIGNED TO CARRY A MAXIMUM
WEIGHT OF 0.44 POUNDS (0.2 KG).
_ THIS ITEM WAS DESIGNED FOR
USE IN COMBINATION WITH 1 PEG-
PÉREGO GANCIOMATIC "PRIMO
VIAGGIO" CAR SEAT (GROUP 0+).
_ BEFORE USE CHECK THAT THE "PRIMO
VIAGGIO" CAR SEAT (GROUP 0+) IS
CORRECTLY FIXED TO THE ITEM.
_ FAILURE TO FOLLOW
MANUFACTURER'S SPECIFICATIONS
OR USE OF ACCESSORIES OTHER
THAN THOSE APPROVED BY THE
MANUFACTURER MAY CAUSE THE
UNIT TO BECOME UNSTABLE.
_ AVOID SERIOUS INJURY FROM
FALLING OR SLIDING OUT. ALWAYS
USE COMPLETE 5 POINT SEAT BELT.
_ NEVER LEAVE YOUR CHILD
UNATTENDED.
_ ALWAYS USE ALL THE BRAKES
WHENEVER PARKED.
_ TO AVOID SERIOUS INJURY, WHEN
MAKING ADJUSTMENTS ENSURE
THE CHILD'S BODY IS CLEAR OF ALL
All manuals and user guides at all-guides.com
_ ALL OPERATING AND ASSEMBLY
_ DO NOT LIFT THE STROLLER BY
_ ENSURE THAT THE STROLLER IS
_ CHECK TO MAKE SURE THAT THE
_ DO NOT DRIVE THIS PRODUCT
_ DO NOT USE THE PRODUCT IF IT HAS
_ DO NOT USE NEAR FIRE OR EXPOSED
_ NOTICE: THIS ARTICLE MEETS OR
COMPONENTS OF THE ITEM
Check the contents of the packaging and for
_ GT3 is composed of: basket; 1 swiveling or
_ This product is numbered progressively.
INSTRUCTIONS FOR USE
1 OPENING: unfasten the safety hook before
Grab the handle with your left hand and use
2 MOUNTING THE HANDLEBAR: remove the
3 Place the cap and the screw (fig_a) and fasten
4 FASTENING THE BRAKE CABLE: to fasten the
- 16 -
MOVING PARTS.
PROCEDURES SHOULD BE
PERFORMED BY AN ADULT.
GRIPPING THE FRONT BAR. THE
FRONT BAR IS NOT DESIGNED TO
WITHSTAND LOADS.
OPENED CORRECTLY AND LOCKED IN
POSITION OF USE.
CAR SEAT OR THE BABY CARRIAGE
IS CORRECTLY FASTENED TO THE
STROLLER (WHERE APPLICABLE).
AROUND STAIRS OR STEPS; CARE
MUST BE TAKEN IF UNIT IS USED ON
STAIRS OR ESCALATORS.
BROKEN OR MISSING PARTS.
FLAME.
EXCEEDS ALL REQUIREMENTS
COVERED IN ASTM F833 STANDARD
AND LATEST REVISIONS.
any complaints please contact the After-Sales
Service.
locking front wheel; 2 rear wheels; front bar;
cover; hood; pouch; rain canopy.
opening the stroller (fig_a).
your right hand to lift the rod all the way up
to the last click (fig_b).
protective packing caps from the stroller rods
(fig_a) and loosen the two screws and two
caps from the handlebar, paying attention
not to lose them (fig_b). Line the handlebar
up with the two rods by pushing it all the way
in (fig_c). Pay attention to the direction of the
handlebar: place it as shown in the figure to
avoid fitting it the wrong way.
(fig_b) on both sides of the handlebar.