V-TAC VT-6605305 Manuel D'instructions page 3

SAFETY GUIDELINES
 After receiving this product, first ma ke sure that the product is well
 Installation of PV inverters must be performed by professional
 Do not carry out any wiring and inspection or changing components

electrical and electronic equipment on the installation site .


local laws and standards.

especially the heat sink may become hot in normal operation. There is a
danger of burning. Do not touch.




Note: Technical personnel who can perform installation, wiring, commissioning,
maintenance, troubleshooting and replacement of the series grid-tied solar inverters
must meet the following requirements:
 Operators need professional training.
 Operators must read this manual completely and master the related safety precautions.
 Operators need to be familiar with the relevant safety regulations for electrical systems.
 Operators need to be fully familiar with the composition and operating principle of the
entire grid -tied photovoltaic power generation system and related standards of the
countries/regions in which the project is located.
 Operators must wear personal protective equipment.
packaged. If you have any questions, please contact the shipping
company or local distributor immediately.
technician who has been specially trained, thoroughly read and familiar
with all the contents of this manual and familiar with the safety
requirements of the electrical system.
when the power supply is applied.
Ensure that there is no electromagnetic interference from other
Do not refit the inverter unauthorized.
All the electric installation needs to be compliance with the national or
The temperature of individual parts o r the enclosure of the inverter–
It must be reliably grounded before operation.
Do not open the cover of inverters unauthorized. The electrical parts
and components inside the inverter are electrostatic. Take
measurements to avoid electrostatic discharge during rel evant
operation.
The inverter must be reliably grounded.
Ensure that DC and AC side circuit breakers have been disconnected
and wait at least 5 minutes before wiring and checking .