MRA EMRAD2020-4025066142736 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA screen
2 metal angles
1 Metal angles
2 rubber nuts
2 spacers, 10mm long
2 rubber washers, 4mm thick
4 screws, M 5 x 16
2 screws, M 5 x 30
4 plastic washers
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Remove the screws and the original windshield (P1).
3. Fasten the metal angles with the screws M 5x16 on the upper fastening
point in the position as shown in P2.
4. Put the screws M 5 x 30 mm with the plastic washers in the lower holes of
the windshield and position the 10 mm long spacers and the 4 mm thick
rubber washers from the inside.
5. Position the windshield and fasten its upper part with the screws M 5x16
with the plastic washers and its lower part with the pre-installed long
screws.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
Triumph Tiger 1200 Explorer
Article No..
--- Allen key 3, 4, 5, 6mm
10746
10671
10629
10633
10634
10554
10566
10635
2
Required tools