Starting And Stopping - Bosch AQUATAK 1200 PLUS Instructions D'emploi

F016 L70 373 - GB Seite 4 Freitag, 21. Oktober 2005 11:10 11

Starting and Stopping

Starting
Connect the product to the mains supply ensuring
that the mains switch is in the (
Open water tap.
Press the safety lock 1 to release the trigger 2.
K
Fully press the trigger 2 until there is a constant flow
of water to clear the air from the machine and water
supply hose. Release trigger 2. Press the trigger
safety lock.
Press button ( ) on main switch 5.
Point the power gun 3 downwards. Press the trigger
safety lock to release the trigger 2. Fully press the
trigger 2.
Stopping
Release trigger 2. Press the trigger safety lock. The
power gun is now locked and can not be operated
accidentally.
Press button ( ) on the main switch 5.
Close water tap. Unplug the machine from the elec-
tric supply.
Press the trigger safety lock 1 to release the trig-
ger 2. Fully press the trigger 2 until there is no more
water pressure in the machine. Release trigger 2.
Press the trigger safety lock 1.
Disconnect water supply hose from machine and
water supply.
Advice using pressure washer
General
Ensure that the machine is on level ground.
Do not overreach with the high pressure hose or
move the pressure washer by pulling the hose, this
could cause the machine to become unstable and
fall over.
Do not kink or drive a motor vehicle over the high
pressure hose. Do not expose the high pressure
hose to sharp edges or corners.
Never use the roto nozzle to clean motor vehicles.
16 • F016 L70 373 • TMS • 14.09.05
Operating with Detergents
Only use Bosch approved detergents. Unsuita-
ble detergents may damage the unit and the ob-
ject being cleaned.
AQUATAK 1200 PLUS
) position.
Attach the detergent-nozzle to the spray gun.
Fill the detergent bottle with suitable detergent and
screw the bottle back on the detergent-nozzle.
AQUATAK 1250
Fill the detergent tank 10 with detergent, dilute
H
as recommended.
To spray detergent move vario-jet-fan power
G
lance to low pressure mode.
We recommend that you use detergent sparingly for
the sake of the environment. Observe the re-
commended dilution on the detergent label.
By offering you an individualised range of cleaning
and preserving agents, Bosch guarantees trouble-
free operation of the unit.
Recommended cleaning method
Step 1: Loosening dirt
Spray on detergent sparingly and allow to react for a
short time.
Step 2: Removing dirt
Spray off the loosened dirt with the high-pressure
spray.
Note: When cleaning a vertical surface spray off
dirt/detergent from the bottom and work in an up-
wards direction. Rinse from the top and work down-
wards.
Maintenance
Note: To ensure long and reliable service, carry out
the following maintenance regularly.
Regularly check for obvious defects such as loose
fixings, and worn or damaged components.
Check that covers and guards are undamaged and
correctly fitted. Carry out necessary maintenance or
repairs before using.
If the pressure washer should happen to fail despite
the care taken in manufacture and testing, repair
should be carried out by an authorised service agent
for Bosch garden products.
For all correspondence and spare parts orders, al-
ways include the 10-digit part number (TYP) from
the nameplate of the machine!
English - 4
Stop, remove plug from the power sup-
ply and disconnect from water supply.