Publicité
Les langues disponibles
Les langues disponibles
Safety Notes
• This locomotive is only to be used with the operating sys-
tem it is designed for.
• Analog max. 15 volts DC, digital max. 22 volts AC.
• This car must never be supplied with power from more
than one transformer.
• Pay close attention to the safety notes in the
instructions for your operating system.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• WARNING! Sharp edges and points required for operation.
• The LEDs in this item correspond to Laser Class 1 accor-
ding to Standard EN 60825-1.
Important Notes
• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Due to technical circumstances, it may be necessary to
adjust the size of the figures that are included with this
car.
• You may need an adapter for the micro-SD card and a
reader device in order to be able to edit the music or the
sounds for this car on a PC.
• The warranty card included with this product specifies
the warranty conditions.
• Disposing: www.maerklin.com/en/imprint.html
8
All manuals and user guides at all-guides.com
Functions
• Changeable music and sounds on the micro-SD card.
• Different interior lighting functions
• The light functions (stroboscope & lighting console) can
Multi-Protocol Operation
Digital Operation
The decoders are multi-protocol decoders. These decoders
can be used under the following digital protocols: mfx or DCC.
The digital protocol with the most possibilities is the highest
order digital protocol. The sequence of digital protocols in
descending order is:
Note: If two or more digital protocols are recognized in the
track, the decoder automatically takes on the highest value
digital protocol.For example, if mfx & DCC are recognized,
the mfx digital protocol is taken on by the decoder.
Notes on digital operation
• The operating instructions for your central unit will give
mfx Protocol
Addresses
• No address is required; each decoder is given a one-
• The decoder automatically registers itself on a Central
be adapted to the direction and the speed levels by using
the settings.
Priority 1: mfx
Priority 2: DCC
Priority 3: DC
you exact procedures for setting the different parameters.
time, unique identifier (UID).
Publicité
