Hartmann Thermoval baby Mode D'emploi page 97

temperature measurement.
9. Calling up the memory function
• The thermometer can call up the last 10 measured values. Press the SCAN
button when the device is switched off to proceed to memory mode. The
memory symbol "M" flashes.
• Press the SCAN button briefly to call up the last measured value. The number
"1" will appear on the display together with the memory symbol "M". The
saved measured value will then be displayed.
• To display the next 9 values, repeatedly press the SCAN button. When you
press the SCAN button again after having called up the 10 measured values,
this sequence will restart with measurement 1.
10. Cleaning and maintenance of the device
• The measuring sensor is the most important and most sensitive part of the
device. In order to ensure most precise measurements, it must be kept clean
and intact.
• Please do not use any aggressive cleaning agents or solvents, as they can
damage the device and make the display intransparent.
1_SpKr_Thermoval_baby_GA_925091_1.indd 95
All manuals and user guides at all-guides.com
• The device is not waterproof. Make sure that no liquid can penetrate the
inside of the thermometer and never immerse the device in water or other
cleaning agents!
• Clean the housing of the device with a moist cloth and a mild detergent or a
suitable disinfectant (e.g. 70 % isopropanol).
• After cleaning the measuring sensor, please be sure to wait until the cleaning
liquid has completely dried off before taking a measurement.
• Keep the thermometer in the storage box to protect it from external influences.
11. Battery replacement
This device is equipped with two alkaline batteries type LR03 (AAA). Replace
spent batteries with two new LR03 batteries as soon as the following symbol
appears in the display " ". Open the battery cover on the rear of the device by
applying gentle pressure on the notch. Now insert two AAA batteries so that the
positive (+) and negative (–) poles on the batteries match the "+" and "–" signs
on the marking in the battery compartment. If the polarities do not match,
the device will not work and the batteries may leak! Replace the battery
compartment lid, applying gentle pressure until the hook snaps into place. The
measured values will remain in the memory when the batteries are changed.
English GB
95
18.08.15 13:23