Publicité
Les langues disponibles
Les langues disponibles
5 Operation – Ventilate
1. Set the fan on the floor, on a level surface.
EN
2. Adjust the stand to the required height. To do so, loosen the height knob (anticlockwise).
Adjust the stand to the required height, and tighten the height knob (by turning it clockwise).
3. Tilt the fan to the required angle. You can set the fan:
- to blow horizontally (position a) or angled slightly downwards (position b). Tilt the
ventilator housing and motor housing to the required angle
- to oscillate from left to right (with a sweep of 90°). This will ventilate much of the
room. Press the oscillation button on the motor housing fully in.
- Remain in the same position while the fan is turning. This will ventilate one area. Pull
out the oscillation button until you hear it click.
4. Put the plug into the wall socket.
5. Switch on the fan by turning the speed dial:
0 = The fan is switched off
I = The fan operates at low speed.
II = The fan operates at normal speed.
III = The fan operates at high speed.
48
Publicité
