Publicité
Les langues disponibles
Les langues disponibles
Mounting – Assembling the fan
1. Remove the thumb screw from the upper end of the pole.
2. Remove the screws from the motor unit bracket.
3. Attach the motor unit to the pole by placing the fan head neck onto the pole.
EN
4. Reinstall the screws on both sides of the motor unit bracket.
5. Install and tighten the thumb screw to hold the motor unit in place.
6. Make sure appliance is disconnected. Remove the 4 safety screws from the motor unit.
7. Install the rear grille with its handle facing to the motor unit using the 4 screws.
8. Remove the rubber part and turn the groove of the motor shaft upwards.
9. Slide the fan blade onto the motor shaft, aligning and tightening the screw to the groove.
10. Hook the front grille onto the rear grille aligning both screw holes.
11. Install the screw and nut to lock the guards. Close the clips.
47 47
Publicité
