Replacing The Fuse; Technical Specifications - EuroLite TMH-150 Mode D'emploi

light-output very quickly. The cooling-fans should be cleaned monthly.
The gobos may be cleaned with a soft brush. The interior of the fixture should be cleaned at least annually
using a vacuum-cleaner or an air-jet.
The dichroic colour-filters, the gobo-wheel and the internal lenses should be cleaned monthly.
There are no serviceable parts inside the device except for the lamp and the fuse. Maintenance and service
operations are only to be carried out by authorized dealers.
Please refer to the instructions under "Installing/Replacing the lamp".

Replacing the fuse

If the lamp burns out, the fine-wire fuse of the device might fuse, too. Only replace the fuse by a fuse of
same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuseholder on the rearpanel with a fitting screwdriver from the housing (anti-
clockwise).
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing and fix it.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
DMX-control-channels:
DMX-512-connection:
Flash-rate:
Colour-wheel:
Static gobo-wheel:
Maximum PAN-movement:
Maximum TILT-movement:
Length of base:
Width of yoke:
Height (head horizontal):
Weight (net):
Maximum ambient temperature t
Maximum housing temperature t
Min.distance from flammable surfaces:
Min.distance to lighted object:
Fuse:
Fitting lamps:
OSRAM HTI 150W 90V/150W GY9,5 750h 6900K
OSRAM HTI 152W 95V/150W GY9,5 2000h 5000K
Recommended controllers:
EUROLITE DMX Operator
Wizard-512 DMX-Software + Interface
Wizard-1024 DMX-Software + Interface
Please note: Every information is subject to change without prior notice. 06.09.2002 ©
230 V/50 Hz
480 W
7/5
3-pin XLR
13 Hz
7 dichroic filters and open
7 gobos and open
360°
250°
330 mm
335 mm
360 mm
12 kg
: 45° C
a
90° C
(steady state):
B
0.5 m
0.5 m
T 8 A, 250 V
No. 91201327
No. 91201329
No. 70064520
No. 51860101
No. 51860110
30/58 51786400X51NXS_V_1_0.DOC