Connection With The Mains; Operation; Addressing - EuroLite TMH-150 Mode D'emploi

Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the TMH-150 starts running. During the Reset, the motors are
trimmed and the device is ready for use afterwards.
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. In order to call up the different features, you first have to open the shutter
(control channel 5, DMX-value 241-255).
Turn the focus-screw next to the objective-lens for adjusting the focus in order to obtain a sharp projection.

Addressing

Each projector occupies 5 channels (8-bit-mode). To ensure that the control signals are properly directed to
each projector, the projector requires adressing. This is to be done for every single projector by changing the
DIP switches as set out in this table.
The starting address is defined as the first channel from which the TMH-150 will respond to the controller. If
you set, for example, the address to channel 6, the TMH-150 will use the channel 6 to 10 for control.
Please make sure that you don't have any overlapping channels in order to control each TMH-150 correctly
and independently from any other fixture on the DMX data link. If two, three or more TMH-150 are addressed
similarly, they will work similarly.
Occupation of the DIP-switches (8-bit-mode):
Setting the DMX-
starting address:
Projector number
& channels
Device 1 - channels 1-5
Device 2 - channels 6-10
Device 3 - channels 11-15
Device 4 - channels 16-20
Device 5 - channels 21-25
International
L
N
1
DIP-switch no.
DMX-starting
1
address
On
Off Off
On
Off
On
Off
On
Off
On
Off
2 3 4 5 6
2 4 8 16 32
27/58
Ω
7 8 9
64 128 256
51786400X51NXS_V_1_0.DOC
resistor