AYA ARIN88/3 Manuel D'utilisation page 44

It is necessary, if not mandatory, to add ventilation under
and behind the product in order to create better airflow and
avoid poor cooling performance, high internal temperatures,
excessive consumption and condensation in the device.
• Setting up and installing the device
1. After unpacking the device, check that the mains voltage
corresponds to that indicated on the nameplate.
2. If the door opens in the desired direction, go to the next
paragraph.
3. Otherwise, reverse the position of the hinges. After that,
carefully lay the unit on its back side, resting it on shims to
avoid crushing the condenser pipes and damaging the com-
pressor unit.
2a Remove the lower axis P
2b Remove the lower axis A and release the door.
2C Remove the top hinge B and mount the hinge A on the
opposite side.
2d Remove the lower support L.
2e Reassemble the door and hinge B on the left side.
2f Reassemble the lower support L on the opposite side.
- 10 -