AL-KO R85.1 Li Traduction De La Notice D'utilisation Originale page 40

GB
4.2 Safety information regarding the
rechargeable battery
This section mentions all the basic safety instruc-
tions to be heeded when using the rechargeable
battery. Read these instructions.
■
Fully charge the rechargeable battery before
using it for the first time and always use the
specified charger. Comply with the details
given in these instructions for use for
charging the rechargeable battery.
■
Do not use the rechargeable battery in envi-
ronments where there is a potential risk of
explosion and/or fire.
■
Do not expose the rechargeable battery to
moisture and humidity when in use with the
appliance.
■
Protect the rechargeable battery from heat,
oil and fire to prevent it being damaged so no
vapours and electrolyte liquids can escape.
There is a danger of explosion!
■
Do not open, dismantle or crush the re-
chargeable battery. There is a danger of
electric shock and short-circuit.
■
An improperly used and damaged recharge-
able battery can cause vapours and electro-
lyte liquid to escape. Vent the room ade-
quately and in the case of any disorders, con-
sult a doctor.
If accidental contact with electrolyte liquid oc-
curs, flush with water and thoroughly rinse
the eyes immediately. Then consult a doctor.
4.3 Safety information regarding the
charging unit
This section mentions all the basic safety and
warning information to be heeded when using the
charging unit. Read these instructions.
■
Only use the charging unit as designated, i.e.
for charging the intended rechargeable bat-
teries. Only charge original rechargeable bat-
teries from AL-KO in the charging unit.
■
Before each use, inspect the entire charging
unit – and especially the mains cable – for
damage. Only use the charging unit when it
is in proper working order.
■
Do not use the charging unit in environments
where there is a potential risk of explosion
and/or fire.
■
Only operate the charging unit indoors and
do not expose it to moisture and humidity.
■
Do not cover the charging unit during the
charging process.
40
■
Before connecting the charging unit, make
sure that the mains voltage matches the volt-
age stated in the "Technical data".
■
Only use the mains cable for connecting the
charging unit, not for any other purpose. Do
not carry the charging unit by the mains cable
and do not remove the power plug from the
power outlet by pulling on the mains cable.
■
Protect the mains cable from heat, oil and
sharp edges to prevent it being damaged.
■
Do not open the charging unit. There is a
danger of electric shock and short-circuit.
■
For your own safety, only have the charging
unit repaired by qualified specialist personnel
using genuine spare parts.
■
Dry the unused charging unit and store in a
closed place. Unauthorised persons and chil-
dren must not have access to the charging
unit.
5 START-UP
5.1 Unpacking the ride-on mower (13, 14)
The ride-on mower is delivered packed in a
wooden crate. For unpacking, choose firm and
level ground with sufficient space for handling the
ride-on mower and packaging. Use the appropri-
ate tool for all work.
WARNING! Risk of personal injury and
damage to the mower mechanism! Improper
unloading of the ride-on mower from the wooden
pallet can cause injury to persons and damage to
the mower mechanism of the ride-on mower.
■
Unload the ride-on mower as described in the
following steps.
1. Carefully remove the cover and side walls
(13/1) from the pallet base (13/2).
2. Remove the packaging foil.
3. Lift out the grass catcher (13/3).
4. Remove the accessory parts (13/4).
5. Remove the packaging foils.
6. Check the scope of supply (see chapter 3.6
"Scope of supply", page 36).
7. Remove the rear transport safety lock (14/1)
and the front transport locks (14/2).
8. Place a loading ramp of suitable width with a
non-slip surface and sufficient strength close
to the pallet floor.
9. Set the mower deck to the uppermost posi-
tion (see chapter 6.6 "Setting the cutting
height", page 43).
Start-up
R85.1 Li