Table des Matières
Publicité
MD2775-CD-Porti-Multi
This CD player can be powered by either two (2) "R6/LR6" batteries or an
external power source, e.g. an AC adapter. When using an external power
source, observe its instructions!
AC Operation
If you use an AC adapter (not included), make sure it is 4.5V
Ð
+
(positive center). Connect it to the jack on the rear of the CD Player
and to an easily accessible wall outlet. The batteries are automatically
disconnected when the AC adapter is used.
Battery Installation
Batteries need to be replaced when the Low Battery indicator appears in the
display.
1. Open the battery compartment door on the bottom of the unit by sliding it
out and then lifting it. To prevent the possibility of losing the cover, it
cannot be removed.
2. Insert two (2) "R6/LR6" batteries (not included) according to the polarity
diagram. Alkaline (LR6) batteries are recommended for longer playing
time.
3. Close the battery compartment.
- Do not mix different types of batteries (e.g. Alkaline and Carbon-zinc)
or old batteries with fresh ones.
- If the device is not to be used for a long period of time, remove the
batteries. They may leak.
21.08.2003
9:23 Uhr
INSTALLATION
BATTERY PRECAUTIONS
20
Seite 20
500 mA
Publicité
Table des Matières
