Mediclinics M09A-UL Manuel D'installation Et D'utilisation page 4


During this process of fitting the casing to the base take care not to damage the
electronic circuit that is below the hand dryer's nozzle (Figure 11).

It is also very important to ensure that once mounted and screwed to the base the
casing has the plastic protector correctly placed on the lower inverted "U" shaped
window (Figure 12).
Figure 11.
NOTE: contemplate a minimum distance of 400 mm (15,80") away from ledges, marble
tops or wash basins (Figure 13). Avoid as much as possible the presence of reflecting
surfaces within the area of the hand dryer's IR sensor.
Adjust the speed of the motor and the detection
distance.
The hand dryer has means to adjust manually the distance for detecting hands and the speed of
the drying air.
These adjustments of the motor speed and detection distance must be made by a
The adjustments can be made by moving the respective cursors of the two linear
potentiometers, as shown in figure 14.
Figure 12.
qualified technician only.
Figure 14.
Figure 14.
Figure 13.