Miele professional PW 6107 Mode D'emploi page 12

Use
Detergent
Only use the correct amount of high efficiency low
sudsing detergent. Too much detergent will cause
over sudsing.
Dosage
Follow the instructions on the detergent packaging to
ensure the correct usage and dosage amount for
your water hardness.
Adjust the amount of detergent if the load is smaller
and more or less soiled than normal.
Water hardness
Water Water
hardness quality
levels
I soft
II moderate
III hard
IV very hard
If you do not know the water hardness in your area
contact your local water authority.
Select a program
^ Select a program by turning the jog shuttle (e.g.
Program 1 Hot Wash), see "Program guide".
The following will appear in the display:
18 Extra Drain
1 Hot Wash
2 Cottons
ä
i
^ Confirm the selected program by pressing the
inner button of the jog shuttle.
The display shows:
1 Hot Wash
194 °F Main wash
Rinse
m k
+i
12
All manuals and user guides at all-guides.com
Hardness German
level in mmol/l hardness
°d
0 - 1.3 0 - 7
1.3 - 2.5 7 - 14
2.5 - 3.8 14 - 21
over 3.8 over 21
194 °F
140 °F
FC A
22.0 /22.0 lb
1200 rpm
A
m
Select wash options (if desired)
^ Press one of the wash option buttons.
To deselect the option, press it again.
+ i Block Plus
A pre-wash can be selected for heavily soiled laundry
in certain program. If a pre-wash is an option the
"+i" field is highlighted. If a pre-wash is not
available, the "+i" will not be shown.
m Starch Stop
Starch can be selected with all standard program
(excluding Extra Spin and Extra Drain). The m field
is highlighted in the display.
k Spin Stop
Spin Stop can be selected with all standard program
(excluding Extra Spin). The k field is highlighted in
the display.
If no additional changes need to be made to the
program:
^ Press "START" and the program will begin.