Replacing The Oil - SKF TMHP Série Mode D'emploi

«БЕРГ АБ», (495) 727-22-72, promshop-biz@ya.ru, www.promshop
3.
1. Open the puller by pushing the boss forward. Place the puller on
the application and close to grip by pulling the boss. Ensure that
the puller legs have a good grip on the workpiece, the claws must
be fully engaged. Tighten the spindle manually.
2. Connect the pump and start injecting oil.
3. The maximum working pressure is 80 MPa (11,600 psi), which
corresponds to the maximum withdrawal forces. Never exceed
the maximum working pressure.
4. When the maximum axial piston displacement (see technical
data) is reached, the pressure will rapidly increase. The piston
should then be pressed to its initial position by opening the
release valve and turning the spindle. Repeat the working cycle
until the workpiece is completely dismounted.
4.
4.1
Protect the puller against corrosion. Inspect all puller components on
a regular time interval.
4.2
When replacing the oil or after maintenance, make sure no air is
trapped in the system. Only use clean, recommended hydraulic oils.
4.3
Keep the cylinder clean from dirt and metal particles in order to avoid
excessive wear.
«БЕРГ АБ», (495) 727-22-72, promshop-biz@ya.ru, www.promshop
8
OPERATING INSTRUCTIONS
MAINTENANCE
General

Replacing the oil

Cleanliness
Self-centring hydraulic pullers SKF TMHP 15/30/50