Maintenance; General; Replacing The Oil; Cleanliness - SKF TMHP 15/260 Mode D'emploi

4. Maintenance

4.1 General

Protect the puller against corrosion. Inspect all
puller components on a regular time interval.

4.2 Replacing the oil

When replacing the oil or after maintenance, make
sure no air is trapped in the system.
Only use clean, recommended hydraulic oils.

4.3 Cleanliness

Keep the cylinder clean from dirt and metal particles
in order to avoid excessive wear.

5. Spare parts

Designation
TMHP 15-1
TMHP 15-5
TMHP 15-11
TMHP 30-1
TMHP 30-2
TMHP 30-3
TMHP 30-5
TMHP 30-11
TMHP 50-1
TMHP 50-2
TMHP 50-3
TMHP 50-5
TMHP 50-11
TMJL 100
Description
Pullerarm - length 264 mm (10.4 in) (standard)
Spindle and centre nib
Repair kit hydraulic cylinder
Pullerarm - length 170 mm (6.7 in)
Pullerarm - length 350 mm (13.7 in)
Pullerarm - length 600 mm (23.6 in)
Spindle and centre nib
Repair kit hydraulic cylinder
Pullerarm - length 140 mm (5.5 in)
Pullerarm - length 320 mm (12.6 in)
Pullerarm - length 570 mm (22.4 in)
Spindle and centre nib
Repair kit hydraulic cylinder
Hydraulic pump
5
1
2
3
TMHP 15 only
4
EN 5