Publicité
Les langues disponibles
Les langues disponibles
Adjustments and Settings Using Menus (continued)
.................................................................................................
SET: DVI INPUT H SYNC
(Horizontal sync signal setting during DVI input)
Sets when horizontal sync signals do not match.
Setting Values: NORMAL, WIDE
Default Value: NORMAL
● This setting is enabled when DVI input is selected.
.................................................................................................
SET: OSD
(On-screen display setting)
Sets whether to display the OSD menu on the screen.
Setting Values: ON, OFF
Default Value: ON
.................................................................................................
SET: OSD TIMER
(OSD timer setting)
Sets the on-screen display time.
Setting Values: 0-255
Default Value: 30
.................................................................................................
SET: LCD TIMER
(LCD timer setting)
Sets the backlight of the LCD.
Setting Values: ALWAYS ON, 06-255
Default Value: 30
.................................................................................................
SET: RS232 ECHO
(RS-232C echo setting)
Set to AONB when returning a RS-232C command from
this unit to an external control device. Please refer to 30
for details on RS-232C codes.
Setting Values: ON, OFF
Default Value: ON
.................................................................................................
SET: BAUD RATE
(RS-232C baud rate setting)
Sets the baud rate of RS-232C.
Setting Values: 9600, 19200, 57600
Default Value: 19200
24
.................................................................................................
SET: SCREEN TRIGGER
(Screen trigger setting)
Controls the screen trigger-compatible elevating screen.
Set this to AONB to output DC +12 V from the [SCREEN]
terminal when the power of this unit is on. No output when
this is set to AOFFB.
Setting Values: ON, OFF
Default Value: ON
.................................................................................................
SET: 1080i TO 1080p
(Output scan rate setting for 1080i signals)
Sets the mode of converting 1080i signals. This is
enabled only when the output scan rate is set to 1080i.
Select AHIGH BANDWIDTH MODEB to convert to a
maximum bandwidth without adjusting the picture image
(level, aspect ratio, etc.). Select AENHANCED MODEB for
a full image adjustment and minimum reduction in
bandwidth.
Setting Values:
HIGH BANDWIDTH MODE, ENHANCED MODE
Default Value: HIGH BANDWIDTH MODE
● This setting is enabled when the image output signal
(ASET: NTSC SCANRATEB or ASET: PAL SCANRATEB)
is set to A1920
1080B or A1920
.................................................................................................
SET: NTSC PROFILE
(Profile setting for NTSC signals)
Stores all setting values of the NTSC signal to the
selected profile number.
Setting Values: STORE PROFILE 1-8
Default Value: STORE PROFILE 1
.................................................................................................
SET: PAL PROFILE
(Profile setting for PAL signals)
Stores all setting values of the PAL signal to the selected
profile number.
Setting Values: STORE PROFILE 1-8
Default Value: STORE PROFILE 1
.................................................................................................
SET: RESTORE FACTORY
(Default setting)
Restores to the factory settings.
● Performing this setting clears all profiles and setting
values.
● Use this command when this unit is unable to function
properly at all, or after all system checks have been
completed.
● Before using this command, unplug the power plug of this
unit. Alternatively, press the reset switch at the front of this
unit (inside the hole) lightly using a non-pointed, stiff thin
rod. This will reset the software without clearing the
settings.
1080/50HzB.
Publicité
