JVC LD-HD2KBU Manuel D'instructions page 12

Accessories/Controls and Features (continued)
Remote Control
Some buttons may not function depending on your input source or unit's settings. A AKEY NOT VALIDB
appear on the LCD if a button that does not function is pressed.
A
VIDEO
B
S-VIDEO
DVD
C
D
PROFILE
1
E
4
7
F
BRIGHTNESS
COLOR
G
ANAMORPHIC
12
H
I
OFF
DVI/RGB YCrCb
PASS/TX
MENU
J
STORE
2 3
5 6
8 9
0
CONTRAST
TINT DETAIL
4:3 LETTERBOX
A
Remote Control's Signal Transmitter
B
Buttons for Input Selection
Sets signals to input to this unit.
[VIDEO] Button
Press this button to select the composite video signal
that has been input to the [VIDEO] input terminal at
the rear of this unit.
[S-VIDEO] Button
Press this button to select the S-video signal that has
been input to the [S-VIDEO] input terminal at the rear
of this unit.
[DVI/RGB] Button
Press this button to select the digital DVI or analog
RGB signal that has been input to the [DVI INPUT] or
[R/G/B/C-SYNC] input terminal at the rear of this unit.
● Input switches between digital DVI and RGB each time
the [DVI/RGB] button is pressed. It is also possible to
specify the DVI and RGB inputs directly.
DVI Input
Press the [DVI/RGB] button, followed by the [0] button
RGB Input
Press the [DVI/RGB] button, followed by the [1] button
[Y/Cr/Cb] Button
Press this button to select the component video signal
that has been input to the [Y, Cr/Pr, Cb/Pb] input
terminal at the rear of this unit.
[DVD] Button
Cannot be used with this processor.
[PASS/TX] Button
Press this to output (pass through) signals that have
been input to the input terminal of this unit in the same
format.
DVI input signals are output to the DVI output terminal
and analog input signals to the analog output terminal
without being transcoded (from YPrPb to RGBHV).
DIGITAL(DVI) N DIGITAL(DVI)
ANALOG RGBHV(D15) N RGBHV(BNC&D15)
YPrPb (BNC&D15) N YPrPb (BNC&D15)
C
Menu Operation [J / K / H / I / MENU] Buttons
Use these to operate the Setup menu and OSD menu.
(A Pages 21, 25)
D
[PROFILE] Button
Press this button to invoke the profile that has been
stored in this unit. (A Pages 19,
message will
26)