Kenwood HMP50 Instructions page 4

Before plugging in
Make sure your electricity supply is the same as the one shown
on the rear of your handmixer.
This appliance conforms to EC Regulation 1935/2004 on
materials and articles intended to come into contact with food.
Before using your handmixer
for the first time
Wash the parts (see
'Cleaning').
Key
Speed & Pulse selector
1
Tool SureEject™
2
Mixer
3
Beaters
4
Kneader
5
Kneader with collar
6
Cord wrap
7
To Use Your
Handmixer
1 Insert the beaters or kneaders
– turn and push until a positive
click is felt.
Important: check that the
kneader with the metal collar
is correctly fitted into the
socket (refer to illustration).
2 Plug in.
3 With the ingredients in a bowl
of an appropriate size, place
the beaters/kneaders into the
bowl.
4 Plug in and select a speed
(Refer to the recommended
usage chart).
As the mixture thickens,
increase the speed.
If the machine starts to slow
or labour, increase the speed.
Slide the speed selector to the
(P) position to use in short
bursts at maximum speed.
Note: the motor will only
operate for as long as the
control is held in position.
5 When the mixture has reached
the desired consistency, return
the speed selector to the off
'O' position and then lift the
beaters/kneaders out of the
bowl.
6 To remove the tools, make
sure the speed selector is in
the off 'O' position and unplug
the handmixer.Slide the tool
SureEject™ down to release
the tools
Note: When ejecting the tools
hold the hand mixer over the
bowl.
Important:
kneaders only - when making
bread dough we recommend
that the dough load does not
exceed 450g flour.
Cord Wrap
Wrap the cord round the heel of
the handmixer, using the cleat to
secure in place.
4
.
2
7