K-FTH-1012 Instructions for Use
Explanation of pictograms
The following pictograms appear on the K-FTH-1012 Test Tube Heater
1
Before connection, read the manual
Consult the operating instructions for information needed for the proper use
of the device
Direct current
Test Tube Heater
CE Mark Approval
IP64
Degree of enclosure protection from dust and water sprayed from all directions
Dispose of in accordance with WEEE directive (2012/19/EU)
Manufacturer
EC Representative
EC REP
Catalogue Code
REF
US REP
REF
SN
Serial Number
SN
The following pictograms appear on the K-APS-300 Power Supply
CE Mark Approval
Dispose of in accordance with WEEE directive (2012/19/EU)
For indoor use only
How to use this manual
Please read this manual completely and follow its instructions carefully. The words WARNING, CAUTION
and NOTE carry special meanings and they should be read carefully.
WARNING:
The personal safety of the patient may be involved. Disregarding this information could result in injury
to the patient or operator, or damage to the device or contents.
CAUTION:
These instructions point out special service procedures or pre-cautions that you must follow to avoid
damaging the device.
NOTE:
This provides special information that facilitates maintenance or clarifies important instructions.
Please pay particular attention to the Safety Instructions.
1-3
English