Kessel KTP 300 Instructions De Montage, D'utilisation Et De Maintenance page 16

The KESSEL submersible pumps KTP 300, 500 GTF 1000 with fully automatic float switch con-
trol can be used as a basement sump pump to dewater basements. In the case that the pump
is to be permanently installed in a sump pit, the installation of a DN 50 conduit allows for proper
power chord installation and also serves as sump pit ventilation in the case that the sump pit is
covered / sealed. Removal of the pump for use elsewhere is always possible.
50er HT-Rohr
Ein
Aus
1. Quick release coupling connection
1 / ''
1
4
2. Reducer connection from
1 ½ inch to 1 ¼ inch
3. Rotatable 1 inch hose connection
CAUTION:
zum Kanal
In the case that the KTP 500 is to be used in a per-
manent application, the body of the pump must be
ventilated. As seen in the KTP 500 illustration there is
a recessed hole on the pump body which should be
drilled out with a 6mm drill bit – this also goes for the
KTP 300 which requires a 4mm drill bit (see illustra-
tion). Be sure to only drill through the pump housing,
do not drill too deep as you may damage the pump.
2. Connection Options
vertical connection - KTP 500/GTF 1000
vertical connection - KTP 500/GTF 1000
vertical connection - KTP 300 only
1. Application
16
KTP 500
KTP 300
horizontal connection - KTP 500 only
horizontal connection - KTP 500 only
horizontal connection - KTP 300 only