Kessel KTP 300 Instructions De Montage, D'utilisation Et De Maintenance page 15

The KESSEL submersible pumps KTP 300,
500 and GTF 1000 were originally deve-
loped as mobile / movable pumps. This
pump is ideal for dewatering excavations
or trenches. With the multiple applications
for which the pump can be used, it also is
ideal for private use.
The KESSEL submersible pumps KTP 300,
500, GTF 1000 can pump out of wells with
a minimum diameter of 200mm as well as
being used in nearby streams or bodies of
water for garden and plant watering. Swim-
ming pools, ponds, excavations and the like
can be easily pumped out by these pumps
which offer vertical and lateral connections.
The KESSEL submersible pumps KTP 300,
500, GTF 1000 should be placed at the lo-
west point of the area being pumped out
where they can sit firmly so that they will
not tilt or rock.
KESSEL Advantage:
1. Application
▪ The threaded connection can easily be
replaced by removing the two screws; no
more jammed hose connections.
▪ The universal submersible pump for use in
water collection tanks / chambers
▪ Maximum depth of submersion: 10 me-
ters
Special KTP 300 Characteristics:
The base / suction basket of the KTP 300
can be removed as to allow a very low
suction height of 8mm (float switch can be
fixed in the 'ON' position to allow the pump
to operate in low water levels).
* Unplug the KTP 300 before removing the
base / suction basket. Be careful when
operating the KTP 300 without the
base / suction basket as the rot-
ating impeller is now exposed.
During mobile use the of the KTP 300, the
supplied non-return flap does not need to
be used – this will allow the outlet pipe or
hose connected to the KTP 300 to drain free
when the pump is not operating.
15
Installation of non-return flap
During fixed use of the KTP 300 (as a per-
manently connected pump or lifting station)
it is recommended that the non-return flap
is used.
Removal/Installation of the non-return
flap
Unscrew and remove the KTP 300 outlet,
remove the non-return flap / if installing
the non-return flap make sure that the flap
opens upward. Re-install the outlet device
with O-ring with the two screws.