SICK GTB2 Flat Serie Instructions D'opération page 7

4 Mounting
5 Electrical installation
8023328.1HTH/2023-03-02 | SICK
Subject to change without notice
1
2
Figure 1: Dimensional drawing
Green LED: supply voltage active
1
Yellow LED: status of received light beam
2
Mount the sensor using a suitable mounting bracket (see the SICK range of accesso‐
ries).
Note the sensor's maximum permissible tightening torque of 0.1 Nm.
Note the preferred direction of the object relative to the sensor, cf.
drawing", page 13.
The sensors must be connected in a voltage-free state (U
tion must be observed, depending on the connection type:
– Plug connection: note pin assignment: when the lid is open, the male connector
can be swiveled horizontally and vertically.
– Cable: wire color
Only apply voltage/switch on the voltage supply (U
tions have been established.
Explanation of the connection diagram (Tables pin assignment):
Q = switching outputs
n. c. = not connected
DC: 10 ... 30 V DC
OPERATING INSTRUCTION
see "Dimensional
= 0 V). The following informa‐
V
> 0 V) once all electrical connec‐
V
O P E R A T I N G I N S T R U C T I O N | GTB2 Flat
en
7