Coleman 2000015123 Instructions D'installation page 3

5
Secure the Guylines
• Attach and stake out guylines. (Fig. 6)
• Adjust sliders to make guylines tight.
Fig. 6
6
disassembly
• Remove stakes and guylines. (Fig. 5 and 6)
• Lower the frame one post at a time by pressing the push
button locks located on lower portion of posts. (Fig. 7)
• Remove the top from frame and fold for storage.
• Press the push buttons found at upper corners of the
frame. (Fig. 8) Collapse shelter frame and store in
carry case.
Push
Button
Fig. 7
Things You should Know:
• Under certain conditions (cold weather, high humidity,
etc.) condensation will form on the inside of your shelter.
Condensation is caused by water vapor from your breath,
perspiration, or any wet clothing inside the shelter. It is NOT
LEAKAGE through the shelter fabric.
• Tree limbs, tree sap, bird droppings, or moisture steadily
dripping off tree limbs can cause damage to the shelter fabric
and its coating resulting in leaks or loss of flame-resistant
properties.
• Never store shelter, even for a short period of time, without
drying it thoroughly and brushing off caked dirt. Do not pack
stakes inside your shelter. Use a separate storage bag.
• Stakes should be removed by pulling on the stake itself. NEVER
PULL ON THE SHELTER TO REMOVE STAKES AS THIS COULD
RESULT IN PROPERTY DAMAGE OR PERSONAL INJURY.
• Do not leave your shelter set-up for weeks at a time. Be aware
that exposure to ultraviolet rays from the sun can seriously
damage material and/or cause it to become discolored.
• This product is not intended to be used during heavy rain, wind,
hail, snow or other inclement weather. Excess water build-up
can cause the frame system to become unstable, and possibly
collapse, causing injury.
Guyline
Push
Fig. 8
Button
7
to Store
1. All stakes must be placed in the storage bag to prevent
damage to the fabric items placed in the carry case.
2. Make sure all components are clean and dry before
placing in carry case.
3. Store in a clean, dry area.
• The shelter top, screen, and sun wall (if included) should be
carefully removed during windy conditions to avoid damage to
product or personal injury.
• DO NOT use gas or flame sources under or near this product.
WARNING: KEEp All FlAmE ANd HEAt SouRcES AWAy FRom
tHIS tENt FAbRIc.
This tent meets the flammability requirements of CPAI-84. This
tent is made of flame-resistant fabric. It is not fireproof. The fabric
will burn if left in continuous contact with a flame source. The
application of any foreign substance to the tent fabric may render
the flame-resistant properties ineffective.
The Coleman Company, Inc. • 3600 North Hydraulic • Wichita, Kansas 67219 U.S.A.
1-800-835-3278 in the United States • www.coleman.com
Sunbeam Corporation (Canada) Limited • DBA Jarden Consumer Solutions
20B Hereford Street • Brampton, ON L6Y 0M1
1-800-387-6161 in Canada • www.coleman.com
MADE IN CHINA
© 2013 The Coleman Company, Inc. All rights reserved.
Coleman , , and are registered trademarks of The Coleman Company, Inc.
®
4010027638 (ECN20030898-01)