Coleman 2000015123 Instructions D'installation page 2

Before you begin
• Read all instructions before set up.
• Select a level site clear of rocks, branches, and other hard or
sharp objects, to install your shelter.
WARNING: Keep clear of overhead power lines.
• Do not set up your shelter under trees because of potential
lightning strikes or falling tree limbs in inclement weather.
• Secure with all stakes and guylines provided to prevent
property damage or personal injury.
• For best results in windy conditions, position narrow end of
shelter into the wind.
• Do not drop shelter.
• Do not bounce shelter bag on its end to remove shelter, as these
actions may damage the frame.
• THIS RECREATIONAL PRODUCT REQUIRES A MINIMUM OF TWO
PEOPLE TO ASSEMBLE.
• Under no circumstances should this product be used to cover
automobiles, marine products or similar items.
CAUTION: Avoid pinch points when opening and closing the
shelter frame.
1
Extend the Shelter Frame
• With two persons standing at diagonal corners of the
structure, grab the leg, and pull out to unfold
frame. (Fig. 1)
NOTE: Do not unfold frame completely. This will allow
easier fit for draping shelter top over frame.
2
Set up the Shelter
• Drape shelter top over frame. (Fig. 2)
• Attach nylon fasteners, located on corners of shelter top,
to four corners of frame post. (Fig. 2A)
Fig. 2
sHELTER sETUP INsTRUCTIONs
Fig. 1
Fig. 2A
MODEL 2000015123
• Pull up sliding bracket
located on upper portion of
leg until push button snaps
into place. (Fig. 3) This will
ensure top of frame is fully
extended.
HANDY TIP: To fully engage the
push button, grip the top and
bottom frame members and
squeeze as shown in Fig. 3A. Be
careful to avoid pinch points.
3
Adjust the Height
• Extend legs until it snaps into place, make sure all four
posts are at the same level. (Fig. 4)
Upper
Portion
of Leg
Fig. 4
4
Stake the Shelter
• Secure shelter by driving stakes through the holes in the
base of each frame post. (Fig. 5)
Fig. 5
Push Button
Fig. 3
Fig. 3A
(continued on other side)