Publicité
Les langues disponibles
Les langues disponibles
FRONT AND REAR SUB-TABLE KIT
KIT PN 2876904
WARNING
Do not inverse the right and left sides.
Rear Anti-rotation Installation
3. Assemble the rear anti-rotation assembly following
these steps :
3.1. Screw the
5/8" nc
of the anti-rotation tube (#5).
3.2. Install the
50mm O.D. X 17mm I.D. X 3mm
washer (#15) onto the threaded part of the anti-
rotation tube (#5).
3.3. Install the bushing spacer tube (#3) onto the
threaded part of the anti-rotation tube (#5).
3.4. Install the rubber bushing (#2) over the bushing
spacer tube (#3).
Figure 10 - Rear anti-rotation assembly (steps 3.1 to 3.4)
3.5. Slide the anti-rotation assembly into the hole
on the bottom of the sub-table (#1).
3.6. Install the rubber bushing (#2) over the bushing
spacer tube (#3).
3.7. Install the
3/4" I.D. X 2" O.D. X 1/8"
(#14) over the bushing spacer tube (#3).
3.8. Install the rubber bushing (#2) over the bushing
spacer tube (#3).
3.9. Install the
50mm O.D. X 17mm I.D. X 3mm
washer (#15) onto the threaded part of the anti-
rotation tube (#5).
2510271
A-2510271 Rév. B
nut (#9) onto the threaded part
flat
flat washer
flat
3.10.Screw the
5/8" nc
threaded part of the anti-rotation tube (#5).
Finger tighten only at this time.
NOTE : Refer to the Track Kit manual to complete the
installation and adjustment.
Figure 11a - Rear anti-rotation assembly (steps 3.5 to 3.10)
Figure 11b - Rear anti-rotation assembly
- 8 -
nylock nut (#12) onto the
Publicité
