ETI EV PLUS Serie Manuel D'installation page 22

Display
Area
All
around LED indicator
the
charger
LED Belt
Colour Blinking mode
White No blinking
Green Blinking slowly
Blue Fast blinking
Blue No blinking
Blue Blinking slowly
Red
7.1.2 Digital character display (AREA1)
The following table shows the format of the information presented by the frontal display:
Display string format
(Letter "c" = single character)
ccc.0
cc.c
cc.c
cc.c
ccc
These data are presented in rotation on the display.
In case of errors/faults/abnormal behaviours, the display can show the following error message
codes. The following table explains the meaning of each error code:
Display string format
ERR OCP
ERR OVP
ERR LVP
ERR MET or
ERR PE
ERR CP
ERR R12
ERR R3N
ERR ROT
ERR ELK
ERR OCT
ERR IRD
ERR FAN
ERR PP
ERR MIS
February 2023
Type
A LED belt is placed all around the charger and assumes different
colours to indicate the current status (see table below)
Power on self-test: the charger is switching on and performing the power on
tests
Stand-By mode: the charger is on, available for charging
Pause during the charging process
Charging mode setup: the charger is preparing to start the charging process
Charging mode: the charging process is ongoing
Error mode: errors are detected by the internal protections
Unit
V
A
Hz
kWH
Min
Over-current fault
Over-voltage fault
Under-voltage fault
Meter communication fault or CAN bus fault
ERR CAN ADDR
Ground fault
CP voltage fault
Relay 1 blocked fault
Relay 2 blocked fault
Relay over-temperature fault
Electronic lock abnormal fault
Plug holder over-temperature fault
Leakage fault
Fan fault (the fan is blocked)
Unreliable connection fault
Missing power phase fault
Function description
Status
Description
Where ccc = Input supply voltage value (V)
Where cc.c = Charging current value (A)
Where cc.c = Input supply voltage frequency (Hz)
Where cc.c = Output power (kWH)
Where ccc = Charging process duration (Min)
Description
20