ETI EV PLUS Serie Manuel D'installation page 14

Step Description
No.
1 Open the
contains the charger and its
accessories.
Package content:
▪
the charger
▪
four expansion screws
▪
a mounting template
▪
a
bracket
attached
charger rear side)
▪
one rubber gland for
the input cable
2 Lean the mounting template
against the wall. The height
from the centre of the template
to the ground should be
determined according to your
ideal height
recommended).
Check the template is fully
horizontally aligned.
Mark the expansion screw holes
positions on the wall.
Create the screw holes with a
tool.
3 Insert the four expansion bolts
into the four holes and just push
them manually or, in case of
resistance, by means of an
hammer
February 2023
Picture
package which
mounting metal
(already
to the
(1500mm is
12