ETI EV PLUS Serie Manuel D'installation page 15

Step Description
No.
4 Open the black front cover of
the charger (this can be done
simply moving at the same time
the two black cursors which
lock the cover in the back side
of the charger)
Remove the anti-theft screw
located on the top of the
mounted bracket (marked with
the red circle in the picture)
Fix the wall mount bracket on
the wall with the expansion
screws
5 Hang the charger on the wall
mounted bracket. This is done
just sliding, from top to bottom,
the charger into the bracket
binaries
Then screw up the anti-theft
screw
6 Use scissors to cut the cross line
of the rubber stopper and pass
the cable through the rubber
stopper
7 Place the cable through the
hole in the bottom of the
charger into the wiring position
inside the charger and then put
the rubber stopper in the hole
position at the bottom
February 2023
Picture
13